![]() Note: Actions that involves kernel modules configuration should be performed on a physical or a virtual machine with full hardware emulation. ![]() If the server is behind the NAT (private IP address is configured in the system), enable the kernel nf_nat_ftp module as well: If a VZ container is used, the same actions should be performed on a hardware node where this VZ container is running.ģ.2. Open the passive ports range in a firewall: Restart the xinetd service to apply changes: IPTABLES_MODULES="nf_conntrack_ftp ip_nat_ftp" # cat /etc/sysconfig/iptables-config | grep IPTABLES_MODULES On CentOS/RHEL-based distributions, add the modules to the IPTABLES_MODULES line in the /etc/sysconfig/iptables-config file as follows: # echo nf_conntrack_ftp > /etc/modules-load.d/nf # echo nf_nat_ftp > /etc/modules-load.d/nf To keep the changes after a system reboot, apply these steps:Īdd the modules to the /etc/modules-load.d/nf file with these commands: Nf_conntrack 131072 3 nf_conntrack_ftp,nf_nat_ftp,nf_natģ.4. Note: If there is an intermediate firewall between a Plesk server and the Internet, make sure that the passive port range is allowed in its configuration as well. Contact your Internet Service Provider for assistance.I am attempting to use the code found here to upload a picture to my FTP server. The code on the page I linked is for Ethernet shields and I am using the original Arduino Wi-Fi shield. ![]() ![]() I am using an Arduino MEGA 2560 and I made some changes to the main FTP code to make it compatible with the Wi-Fi shield I am using. Serial.println(F("Command disconnected")) If(clientCount > 0) dclient.write(clientBuf,clientCount) Serial.println(F("Command connection failed")) change fileName to your file (8.3 format!) comment out next line to write to SD from FTP serverīyte mac = Here is the edited code I uploaded on the Arduino: /*įTP passive client for IDE v1.0.1 and w5100/w5200 Regarding the connections, I mounted the shield and inserted the micro SD card and have done nothing else. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |